Description: PROFESSIONAL INSTALL RECOMMENDED! I AM NOT RESPONSIBLE FOR POOR FITMENT OR LOSS OF THE LENS IF INSTALLED IMPROPERLY! I've created a 3d printed clear lens for the 2019-24 Corolla Hatchback 3rd brake light / center brake light / high mount brake light. It is printed in clear PETG. To remove your your 3rd brake light follow these steps: 1. Open your hatch2. Once opened, you'll see a access panel at the top of the hatch, use a flathead screwdriver or panel trim removing tool to pry off the access panel.3. Looking at the picture #4, remove the two 10mm nuts on the left and right side of the assembly, a small 10mm speed wrench or ratchet with a short socket will do the job easily. Be careful not to drop the nuts within the access panel as you could lose them or have a hard time retrieving.4. Unplug the single connector.5. There is a locking tab on the connector on the brake light assembly, use a flat head screwdriver to press this tab in to be able to release the brake light assembly from the hatch. Installation of the lens: 1. Once you have removed the assembly from the car, take a good look around the assembly, you'll see where the red lens meets the black housing, this is the line you will follow to cut the red lens off.2. A dremel or an oscillating tool is highly recommended to cut the lens off. Using one of the tools, cut the red lens off of the assembly. DON'T CUT TOO DEEP OR YOU RISK CUTTING THE LED BOARD!! 3. Once the red lens is cut off, clean up your cut. The more flat and even the mating surface is, the better the fitment will be with the new lens.4. I recommend using waterproof silicone OR seam sealer OR windshield adhesive to adhere the new lens onto the assembly. Pick your favorite and run a small bead around the edge of the assembly where the lens will sit.5. Line up the new lens with the assembly and put them together, you may need to adjust how it sits. Clean up any excess adhesive, if there is any blobs of adhesive on the outside of the lens, it may affect fitment on the car.6. LET THE ADHESIVE CURE! If you install the brake assembly too early, the lens may fall off upon installation and you may get adhesive where you don't want it.7. Reinstall the brake light assembly doing the reverse of the removal process.8.ENJOY!
Price: 49.99 USD
Location: Santa Clara, California
End Time: 2024-10-01T18:34:48.000Z
Shipping Cost: N/A USD
Product Images
Item Specifics
Returns Accepted: ReturnsNotAccepted
Brand: Unbranded
Type: Third Brake Light Assembly
Voltage: 24 V
Placement on Vehicle: Center, Rear
